Vulcanizing machine as a conveyor belt joint tool, in the use process and after the end of use, but also like other tools, maintenance and maintenance to extend the service life. At present, the machine produced by our company, as long as it is properly maintained, its service life is 8 years.

1, the machine storage environment should be kept dry, well ventilated, to avoid damp electrical lines caused by humidity;

2, do not use vulcanization machine outdoors in rainy days, to prevent the electric control box and heating plate water;

3, if the working environment is wet and watery, when disassembling the handling machine, items should be padded high on the ground, and the machine should not be in direct contact with water;

4, if in the process of use, due to improper operation of the heating plate water, should be first repaired. If emergency repair is needed, the cover plate on the heating plate can be opened, the water can be poured out first, and then the electric control box is set to manual operation, the temperature is heated to 100 degree C, the temperature is maintained for half an hour, the line is dried, and the belt is bonded in the manual state. At the same time, the whole line should be replaced in time.

5. If the machine is not needed for a long time, the heating plate should be heated every half month (the temperature is set at 100 degree C) and the temperature should be kept for about half an hour.

6, after each use, the water in the water pressure plate should be put clean, especially in winter, if the water can not be put clean, often lead to premature aging of the water pressure plate rubber, water pressure plate service life is reduced;